Showing all 11 results
1 1/2″x 5/16″ lag bolt for post wall connectors, 2 required per connector$0.29 Add to cart
9001M Post/Wall Connector for use at Female End of panel, upper connection$15.00 Add to cart
9002M Post/Wall Connector for use at Female end of panel , lower connection$10.00 Add to cart
9101F Post/Wall Connector for use at Male End of panel, upper and lower$9.00 Add to cart
Gate Latch$17.00 Add to cart
Screw gate hook$5.29 Add to cart
3ft Alligator Strap$3.99 Add to cart
2ft Alligator Strap$2.99 Add to cart
Gate Strap Small$3.99 Add to cart
Kiwi Gate latch w/ chain & Staple$5.99 Add to cart
Panel touch-up spray paint$5.99 Add to cart
Post/Wall Connectors are used to secure the ends of the mesh panels to a post or wall utilizing the same “pin & pipe” connector system. The Post/Wall Connectors duplicate the end of a panel and receive the connection from the panel that is terminating at the wall or post. The Post/Wall Connectors are lagged to the wall or post using a standard 5/16” or 3/8” lag bolt (not included). Length of lag bolt will depend on installation conditions and is to be determined by installer however 1 ½” minimum is recommended. Click on the connectors in the above picture to see an enlarged picture of each connector
Post / Wall Connectors9002M (top) is the Y shaped pin, lower connector for the female end of the panel
9101F (middle) is the double pipe, upper and lower connector for the male end of the panel
9001M (bottom) is the one w/ the movable pin, upper connector for the female end of the panel
Note: the lag bolts are not included with the connectors but can be purchased above.
The lower post/wall connector for the female end of the panel (9002M) is installed with the hook pointing up. This allows the panel that is being attached to the post or wall to slide down onto the connector.
To estimate the number of post/wall connectors needed follow these guidelines:
For larger jobs and quicker estimating:
Count the total number of terminations
Multiply the number of terminations
by the following:
- .5) 9001M
- .5) 9002M
- 1) 9101F
- 30 total terminations
- .5 x 30 = 15) 9001M
- .5 x 30 = 15) 9002M
- 1 x 30 = 30) 9101F
This assumes that half of the terminations will be male and half will be female.
To be safe add a couple extra of each connector.
If you have a plan layout of your barn or paddocks where our panels and post/wall connectors will be used I’ll gladly estimate the number of connectors needed.